Cisco Cisco Aironet 1522 Lightweight Outdoor Mesh Access Point Guía De Instalación

The access point has a reset button located on the bottom of the unit (see 

). The reset button is 

recessed in a small hole that is sealed with a screw and a rubber gasket. The reset button can be used to 
perform these functions:

Reset the access point—press the reset button for less than 10 seconds.

Disable battery backup power—press the reset button for more than 10 seconds.

To reboot (power cycle) the access point, follow these steps:

Use a Phillips screwdriver to remove the reset button screw. Be careful not to loose the screw.

Use a straighten paperclip, and push the reset button for less than 10 seconds. This causes the access 
point to reboot (power cycle), all LEDs turn off for approximately 5 seconds and then the LEDs 
reactivate.

Replace the reset button screw, and use a Phillips screwdriver to tighten to 22 to 24 in. lbs
(2.49 to 2.71 Nm).

Reset button location