Cisco Cisco Aironet 1522 Lightweight Outdoor Mesh Access Point Guía De Instalación

To forward bridge traffic, add a switch between the power injector and controller. Refer to the 
Deployment Guide: Cisco Mesh Networking Solution for more information. 

Ensure that the antennas are connected and that a ground is attached to the access point before you apply 
power to the access point.

Connect a shielded outdoor-rated Ethernet (CAT5e or better) cable between the power injector and the 
access point’s PoE-in connector (see 

).

Connect the Ethernet cable to the access point PoE-in port (see 

Continue with the 

You need to supply these:

Shielded outdoor-rated Ethernet (CAT5e or better) cable with 0.2 to 0.35 in. (0.51 to 0.89 cm) 
diameter

The Ethernet cable from the power injector to the access point must be at least 10 ft 
(3.05 m) long. The PoE-out port is disabled when the access point is powered by the power 
injector.

RJ-45 connector and installation tool

Adjustable wrench

To connect the shielded Ethernet cable to the access point, follow these steps:

Disconnect power to the power injector, and ensure all power sources to the access point are turned-off.

This unit might have more than one power supply connection. All connections must be removed to 
de-energize the unit. Statement 1028

If your access point contains a backup battery pack, you must press the reset button for 10 
seconds or more (see the

 

).

Ensure a 6 AWG ground wire is connected to the access point (see the 

Use an adjustable wrench, a 22 mm socket, or the Sealcon S-2200-WR wrench to remove the Ethernet 
connector plug from the access point (see 

 for the location).