Cisco Cisco ASA for Nexus 1000V Series Switch Guía De Instalación
4
2
Deploy the ASA
•
ASAv—See the Cisco Adaptive Security Virtual Appliance (ASAv) Quick Start Guide for
installation procedures, at the following URL:
installation procedures, at the following URL:
Note
During ASAv deployment, you must define the value of the nameif property for the
management interface as management. If you define the interface name as anything other
than management, the device cluster will be stuck in AuditRequested/AuditPending state,
and the fault will indicate that the read operation timed out. The management interface
and default gateway configuration are deleted from the ASAv, and the interface is shut
down.
management interface as management. If you define the interface name as anything other
than management, the device cluster will be stuck in AuditRequested/AuditPending state,
and the fault will indicate that the read operation timed out. The management interface
and default gateway configuration are deleted from the ASAv, and the interface is shut
down.
•
ASA 5585-X—See the Cisco ASA 5585-X Quick Start Guide for installation procedures, at the
following URL:
following URL:
3
Configure Management Access to the ASA
You must configure management access to the ASA so that the APIC can manage the ASA.
To configure management access to the ASAv, see
.
To configure management access to the ASA 5585-X, see the following procedure:
Step 1
Remove any existing configuration:
ciscoasa(config)# clear configure all
Step 2
(Optional) Set the firewall mode to transparent firewall mode:
ciscoasa(config)# firewall transparent
Static Routing
Yes
Yes
TCP Intercept (Embryonic Connection Limits)
Yes
Yes
Threat Detection
Yes
Yes
Feature
ASAv Support
(Yes/No)
(Yes/No)
ASA 5585-X Support
(Yes/No)
(Yes/No)