Cisco Cisco Aironet 1530i Outdoor Access Point Guía De Instalación
17
Step 6
Under Radio Configuration, for Radio 2.4 GHz, set the following configuration values:
Note
The 5 GHz radio will be Scanner mode. It cannot be configured until the AP is primed.
Step 7
Click Apply to save your settings.
Step 8
Click Network Interfaces to browse to the Network Interfaces Summary page.
Step 9
Click the Dot11Radio 0 radio interface to browse to the Network Interfaces: Radio Status
page.
page.
Step 10
Click the Settings tab to browse to the Settings page for the radio interface.
Step 11
Click Enable to enable the radio.
Step 12
Click Apply.
Step 13
Go to Security > SSID Manager.
This opens the Security: Global SSID Manager page.
This opens the Security: Global SSID Manager page.
Step 14
In the Current SSID List, click the SSID associated to 2.4 GHz radio (as configured in
).
For that SSID, check the Universal AP Admin Mode check box.
Step 15
Click Apply to save your settings.
Configuration Field
To be set as
SSID
Enter the SSID to be broadcasted by the radio.
The SSID that is specified for the 2.4 GHz radio is the same one to
which the smartphone running Cisco AirProvision should connect
to during priming.
which the smartphone running Cisco AirProvision should connect
to during priming.
Broadcast SSID in Beacon
Check this check box
Universal AP Admin Mode
Enable
Security
WPA/WPA2
Role in Radio Network
Access Point
VLAN
No VLAN.
However, if you are using a VLAN, then it should be able to reach
the autonomous AP's management IP address.
the autonomous AP's management IP address.
Optimize Radio Network for
Default
Aironet Extensions
Enable
Channel
Least-Congested
Power
Maximum