Cisco Cisco FirePOWER Appliance 7010 Guía De Instalación

      

  Restoring a Device to Factory Defaults

Firepower 7000 Series Getting Started Guide

 (optional) — 

 — see 

.

 — see 

.

Identifying the Appliance’s Management Interface

The first step in running the restore utility is to identify the management interface on the appliance you want to 
restore, so that the appliance can communicate with the server where you copied the ISO and any update files. If 
you are using LOM, remember that the management IP address for the appliance is not the LOM IP address.

From the main menu, select 

.

Select the appliance’s management interface (generally 

).

Select the protocol you are using for your management network: 

 or 

.

Options for assigning an IP address to the management interface appear.

Select a method to assign an IP address to the management interface: 

 or 

:

If you select 

, a series of pages prompts you to manually enter the IP address, network mask or prefix 

length, and default gateway for the management interface.

If you select 

, the appliance automatically detects the IP address, network mask or prefix length, and 

default gateway for the management interface, then displays the IP address.

When prompted, confirm your settings.

If prompted, confirm the IP address assigned to the appliance’s management interface.



Continue with the next section, 

.

Specifying ISO Image Location and Transport Method

After you configure the management IP address that the restore process will use to download files it needs, you 
must identify which ISO image you will use to restore the appliance. This is the ISO image that you downloaded 
from the Support Site (see 

), and stored on a web server, FTP 

server, or SCP-enabled host. 

The interactive menu prompts you to enter any necessary information to complete the download, as listed in the 
following table.