Cisco Cisco FirePOWER Appliance 7010 Guía De Instalación
Cabling the Device
Firepower 7000 Series Getting Started Guide
7
Connecting the Sensing Interfaces
After you cable the interfaces, use the web interface on the Firepower Management Center that manages the
device to configure the device’s sensing interfaces as passive, inline, inline with fail-open, switched, routed, or
hybrid. Use only the interfaces on the front of the device as sensing interfaces.
device to configure the device’s sensing interfaces as passive, inline, inline with fail-open, switched, routed, or
hybrid. Use only the interfaces on the front of the device as sensing interfaces.
See the Firepower 7000 Series Hardware Installation Guide for detailed information on planning your deployment.
After you have selected a deployment model, cable the sensing interfaces as needed for your configuration.
After you have selected a deployment model, cable the sensing interfaces as needed for your configuration.
Passive Interface Cabling
For each network segment you want to monitor passively, connect the appropriate cables (either fiber or copper)
to one sensing interface.
to one sensing interface.
Use this cabling when you want to configure passive interfaces.
Firepower 7010/7020/7030/7050
Firepower 7110/7120
Firepower 7115/7125, AMP7150