Cisco Cisco FirePOWER Appliance 7010 Guía De Instalación
Cabling the Device
Firepower 7000 Series Getting Started Guide
8
Inline Interface Cabling
For each network segment you want to monitor inline, connect the appropriate cables (either copper or fiber
sequentially to pairs of sensing interfaces.
sequentially to pairs of sensing interfaces.
Use this cabling when you want to configure inline, inline with fail-open, switched, routed, or hybrid interfaces.
Firepower 7010/7020/7030/7050
Inline with Fail-Open Configuration
If you want to take advantage of the device’s configurable fail-open capability, you must cable a sequential pair
of vertical interfaces (interfaces 1 and 2, 3 and 4, 5 and 6, or 7 and 8) to a network segment.
of vertical interfaces (interfaces 1 and 2, 3 and 4, 5 and 6, or 7 and 8) to a network segment.
After you cable the interfaces, use the web interface on the Defense Center that manages the device to configure
the interface as inline with fail-open. See Setting Up an IPS Device in the Firepower Management Center
Configuration Guide.
the interface as inline with fail-open. See Setting Up an IPS Device in the Firepower Management Center
Configuration Guide.
Firepower 7110/7120
Inline with Fail-Open Configuration
If you want to take advantage of the device’s configurable fail-open capability, you must cable a sequential pair
of interfaces (interfaces 1 and 2, 3 and 4, 5 and 6, or 7 and 8) to a network segment.
of interfaces (interfaces 1 and 2, 3 and 4, 5 and 6, or 7 and 8) to a network segment.
After you cable the interfaces, use the web interface on the Defense Center that manages the device to configure
the interface as inline with fail-open. See Setting Up an IPS Device in the Firepower Management Center
Configuration Guide.
the interface as inline with fail-open. See Setting Up an IPS Device in the Firepower Management Center
Configuration Guide.