Cisco Cisco Industrial Wireless 3702 Access Point Notas de publicación
2
Release Notes for Cisco Aironet Access Points for Cisco IOS Release 15.3(3)JBB5
Contents
•
AP 3600 (AIR-RM3000AC-x-K9 802.11ac module is not supported)
•
AP 3700 (AIR-RM3000AC-x-K9 802.11ac module is not supported)
Warning
Install only Cisco IOS Release 15.3(3)JA1 and newer releases on Cisco Aironet Universal Access
Point models. Do not install older Cisco IOS releases on Cisco Aironet Universal Access Point
models as that is a violation of local radio regulations and laws.
Point models. Do not install older Cisco IOS releases on Cisco Aironet Universal Access Point
models as that is a violation of local radio regulations and laws.
Contents
These release notes contain these sections:
•
•
•
•
•
•
•
Obtaining Documentation, Obtaining Support, and Security Guidelines, page 19
Introduction
The Cisco Aironet Access Point is a wireless LAN transceiver that acts as the connection point between
wireless and wired networks or as the center point of a standalone wireless network. In large
installations, the roaming functionality provided by multiple access points enables wireless users to
move freely throughout the facility while maintaining uninterrupted access to the network.
wireless and wired networks or as the center point of a standalone wireless network. In large
installations, the roaming functionality provided by multiple access points enables wireless users to
move freely throughout the facility while maintaining uninterrupted access to the network.
System Requirements
You can install the 32 MB Cisco IOS Release 15.2(4)JB3a on all 802, 1040, 1140, 1260, 1550, 1600,
2600, 3500, and 3600 series access points. New APs 702 and 1530 support 128 MB minimum flash and
AP 3700 supports 64 MB minimum flash.
2600, 3500, and 3600 series access points. New APs 702 and 1530 support 128 MB minimum flash and
AP 3700 supports 64 MB minimum flash.
Finding the Cisco IOS Software Release
To find the version of Cisco IOS software that is running on your access point, use a Telnet session to
log into the access point, and enter the show version EXEC command. This example shows command
output from an access point that is running Cisco IOS Release 15.3(3)JBB5:
log into the access point, and enter the show version EXEC command. This example shows command
output from an access point that is running Cisco IOS Release 15.3(3)JBB5:
ap1260AG> show version
Cisco IOS Software, C1260 Software (AP3G1-K9W7-M), Version 15.3(3)JBB5
Copyright (c) 1986-2010 by Cisco Systems, Inc.