Cisco Cisco Aironet 1400 Wireless Bridge Notas de publicación
4
Release Notes for Cisco Aironet 1410 Bridges for Cisco IOS Release 12.2(11)JA
OL-4086-01
Installation Notes
Key Bridge Features
The following are key bridge features:
•
Unlicensed UNII-3 5.8-GHz radio operation
•
Integrated antenna or external antenna configurations
a.
Integrated antenna configuration—with 22.5-dBi patch array
b.
External antenna configuration—with an antenna connector for an external antenna
•
Metal enclosure supports outdoor installations
a.
Integrated antenna configuration—the enclosure has been successfully
tested for protection
against the ingress of particulate matter and fluids in compliance with a NEMA Type 4 (IP56)
enclosure rating.
enclosure rating.
b.
External antenna configuration—the enclosure has been successfully
tested and is in
compliance with a NEMA Type 4 (IP56) enclosure rating.
•
Industrial temperature rating—operating temperature of –22 to 131
o
F (–30 to 55
o
C)
•
Power injector dual-coax ports supports:
–
100-Mbps Ethernet over dual-coax cables
–
Inline power over dual-coax cables
•
Four LED indicators on bridge
–
Install, Radio, Status, and Ethernet
•
Receive Signal Strength Indicator (RSSI) voltage port for easy antenna alignment
•
Bridge control using Cisco IOS commands, Internet browser, or SNMP
•
Point-to-point and point-to-multipoint bridge operation
•
Three optional external bridge antennas
–
9-dBi omnidirectional external antenna with vertical polarization
–
9.5-dBi sector external antenna
–
28-dBi dish external antenna
Installation Notes
This section contains important information to keep in mind when installing your bridge.
Warnings
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before
you work on any equipment, be aware of the hazards involved with electrical circuitry and be
familiar with standard practices for preventing accidents.
you work on any equipment, be aware of the hazards involved with electrical circuitry and be
familiar with standard practices for preventing accidents.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.