Cisco Cisco Email Security Appliance C650 Referencia técnica
C H A P T E R
2-1
CLI Reference Guide for AsyncOS 9.6 for Cisco Email Security Appliances
2
Command Line Interface: The Basics
This chapter contains the following sections:
•
•
Accessing the Command Line Interface (CLI)
The Command Line Interface is accessible via SSH or Telnet on IP interfaces that have been configured
with these services enabled, or via terminal emulation software on the serial port. By factory default,
SSH and Telnet are configured on the Management port. Use the
with these services enabled, or via terminal emulation software on the serial port. By factory default,
SSH and Telnet are configured on the Management port. Use the
interfaceconfig
command to disable
these services.
Access to the CLI varies depending on the management connection method chosen while setting up the
appliance. The factory default username and password are listed next. Initially, only the admin user
account has access to the CLI. You can add other users with differing levels of permission after you have
accessed the command line interface for the first time via the admin account. The system setup wizard
asks you to change the password for the admin account. The password for the admin account can also
be reset directly at any time using the
appliance. The factory default username and password are listed next. Initially, only the admin user
account has access to the CLI. You can add other users with differing levels of permission after you have
accessed the command line interface for the first time via the admin account. The system setup wizard
asks you to change the password for the admin account. The password for the admin account can also
be reset directly at any time using the
password
command.
To connect via Ethernet: Start an SSH or Telnet session with the factory default IP address
192.168.42.42. SSH is configured to use port 22. Telnet is configured to use port 23. Enter the username
and password below.
192.168.42.42. SSH is configured to use port 22. Telnet is configured to use port 23. Enter the username
and password below.
To connect via a Serial connection: Start a terminal session with the communication port on your
personal computer that the serial cable is connected to. See the “Setup and Installation” chapter for more
information. Enter the username and password below.
personal computer that the serial cable is connected to. See the “Setup and Installation” chapter for more
information. Enter the username and password below.
Log in to the appliance by entering the username and password below.
Factory Default Username and Password
•
Username:
admin
•
Password:
ironport
For example:
login: admin
password: ironport