Cisco Cisco Email Security Appliance C670 Guía Del Usuario
9-10
Cisco IronPort AsyncOS 7.6 for Email Configuration Guide
OL-25136-01
Chapter 9 Anti-Spam
Note
The proxy server setup is available via the Security Services > Service Updates page. For more
information about specifying a proxy server, see
information about specifying a proxy server, see
. Note that the
proxy server is global in that all services that are configured to use a proxy server will use the same proxy
server.
server.
Note
If you chose to enable Cisco IronPort Intelligent Multi-Scan in the GUI’s system setup wizard (or the
CLI
CLI
systemsetup
command), it will be enabled for the default incoming mail policy with the default
values for the global settings.
shows the global settings that you configure on the Security-Services > IronPort Intelligent
Multi-Scan page.
Figure 9-7
Cisco IronPort
Intelligent Multi-Scan Global Settings: Editing
To enable Cisco IronPort Intelligent Multi-Scan, follow these steps:
Step 1
If you did not enable Cisco IronPort Intelligent Multi-Scan in the system setup wizard, select Security
Services > IronPort Intelligent Multi-Scan.
Services > IronPort Intelligent Multi-Scan.
Step 2
Click Enable.
The license agreement page is displayed.
Note
If you do not accept the license agreement, Cisco IronPort Intelligent Multi-Scan is not enabled
on the appliance.
on the appliance.
Step 3
Scroll to the bottom of the page and click Accept to accept the agreement.
A page similar to
is displayed.
Step 4
Click Edit Global Settings.
Step 5
Check the box next to Enable IronPort Intelligent Multi-Scan.
Checking this box enables the feature globally for the appliance. However, you must still enable
per-recipient settings in Mail Policies. For more information, see
per-recipient settings in Mail Policies. For more information, see
.
Step 6
Choose a value for the maximum message size to scan by Cisco IronPort Intelligent Multi-Scan.
The default value is 128 Kb. Messages larger than this size will not be scanned by Cisco IronPort
Intelligent Multi-Scan.
Intelligent Multi-Scan.
Step 7
Enter the number of seconds to wait for timeout when scanning a message.
When specifying the number of seconds, enter an integer from 1 to 120. The default value is 60 seconds.
Step 8
Submit and commit your changes.