Cisco Cisco Email Security Appliance C160 Guía Del Usuario
Chapter 3 Configuring Routing and Delivery Features
3-160
Cisco IronPort AsyncOS 7.3 for Email Advanced Configuration Guide
OL-23081-01
Step 1
You can use the
altsrchost
command to map email from specific sender IP
addresses or Envelope Sender address information to a host IP interface (Virtual
Gateway address) or interface group for delivery.
Gateway address) or interface group for delivery.
Step 2
Using message filters, you can set up specific filters to deliver flagged messages
using a specific host IP interface (Virtual Gateway address) or interface group.
See
using a specific host IP interface (Virtual Gateway address) or interface group.
See
method is more flexible and powerful than the one above.)
For more information about creating IP interfaces, see the “Accessing the
Appliance” appendix in the Cisco IronPort AsyncOS for Email Configuration
Guide.
Appliance” appendix in the Cisco IronPort AsyncOS for Email Configuration
Guide.
So far, we have been using an Email Gateway configuration with the following
interfaces defined as shown in
interfaces defined as shown in
Figure 3-15
Example Public and Private Interfaces
Ethernet interface: Data 2
IP interface: PublicNet 192.168.2.1
IronPort Email
Security appliance
Ethernet interface: Data 1
IP interface: PrivateNet 192.168.1.1)
In the following example, the IP Interfaces page confirms that these two interfaces
(PrivateNet and PublicNet) have been configured, in addition to the Management
interface.
(PrivateNet and PublicNet) have been configured, in addition to the Management
interface.