Cisco Cisco Aironet 1130 AG Access Point Notas de publicación
16
Release Notes for Cisco Aironet Access Points for Cisco IOS Release 12.3(8)JEA
OL-11186-01
Important Notes
Repeater Access Points Cannot Be Configured as WDS Access Points
Repeater access points can participate in WDS but they cannot provide WDS. You cannot configure a
repeater access point as a main WDS access point, and if a root access point becomes a repeater in
fallback mode, it cannot provide WDS.
repeater access point as a main WDS access point, and if a root access point becomes a repeater in
fallback mode, it cannot provide WDS.
Crossover Cable Sometimes Needed When Ethernet Speed and Duplex Set to
Fixed on 1100 Series Access Points
Fixed on 1100 Series Access Points
If you change the speed and duplex settings from auto to fixed on an 1100 series access point’s Ethernet
port, the auto-MDIX feature on the port is disabled. When auto-MDIX is disabled, you must determine
whether to use a straight-through or a crossover cable to connect the access point Ethernet port to another
device. If the Ethernet link goes down after you set the speed and duplex to fixed, try changing the
Ethernet cable from crossover to straight-through or from straight-through to crossover.
port, the auto-MDIX feature on the port is disabled. When auto-MDIX is disabled, you must determine
whether to use a straight-through or a crossover cable to connect the access point Ethernet port to another
device. If the Ethernet link goes down after you set the speed and duplex to fixed, try changing the
Ethernet cable from crossover to straight-through or from straight-through to crossover.
Cannot Perform Link Tests on Non-Cisco Aironet Client Devices and on Cisco
Aironet 802.11g Client Devices
Aironet 802.11g Client Devices
The link test feature on the web-browser interface does not support non-Cisco Aironet client devices nor
Cisco Aironet 802.11g client devices.
Cisco Aironet 802.11g client devices.
System Software Upgrade Sometimes Fails Using Microsoft Internet Explorer
5.01 SP2
5.01 SP2
A system software upgrade sometimes fails when you use Microsoft Internet Explorer 5.01 SP2 to
upgrade system software using the TFTP Upgrade page in the web-browser interface. Use a later version
of Microsoft Internet Explorer to perform HTTP system software upgrades, or use TFTP to upgrade
system software. Click this URL to browse to the Cisco IOS Software Configuration Guide for Cisco
Aironet Access Points for complete instructions on performing software upgrades:
upgrade system software using the TFTP Upgrade page in the web-browser interface. Use a later version
of Microsoft Internet Explorer to perform HTTP system software upgrades, or use TFTP to upgrade
system software. Click this URL to browse to the Cisco IOS Software Configuration Guide for Cisco
Aironet Access Points for complete instructions on performing software upgrades:
1100 Series Access Points with Boot Loader Version 12.2(4)JA Boot into
Monitor Mode
Monitor Mode
When the Ethernet port is disabled on an 1100 series access point running boot loader version 12.2(4)JA,
the access point boots into monitor mode when it reboots. To avoid this problem, connect the access
point Ethernet port to one of the following:
the access point boots into monitor mode when it reboots. To avoid this problem, connect the access
point Ethernet port to one of the following:
•
a wired LAN
•
the Ethernet port on a PC
Remove power from the access point and reapply power to reboot the unit. When the access point senses
an Ethernet connection, it boots normally.
an Ethernet connection, it boots normally.