Cisco Cisco Aironet 1200 Access Point Notas de publicación
4
System Requirements
OL-2898-01
Installation Notes
Figure 1
Improper Power Configuration Using Two Power Sources
Access Point Requires 1200 Series Universal Power Supply and Power Injector
You must use a 1200 series universal power supply to power the access point. If you need to use a power
injector to inject power into the access point’s Ethernet port, you must use a 1200 series power injector.
The 350 series universal power supply and power injector are not compatible with the 1200 series access
point.
injector to inject power into the access point’s Ethernet port, you must use a 1200 series power injector.
The 350 series universal power supply and power injector are not compatible with the 1200 series access
point.
System Requirements
You must have a 1200 series access point to install firmware version 11.42T.
Version Supported
Your access point must be running firmware version 11.40T or later to install firmware version 11.42T.
Upgrading to a New Firmware Release
Determining the Firmware Version
The firmware version number is in the upper-left corner of most management screens in the web-browser
interface and at the top of the home (Summary Status) page in the command-line interface.
interface and at the top of the home (Summary Status) page in the command-line interface.
Upgrade Procedure
For instructions on installing access point firmware:
1.
Follow this link to the Cisco Aironet documentation home page:
Universal
power supply
SYST
RPS
DUPLX
MODE
SPEED
UTIL
STAT
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
23
24
10Base-T / 10
0Base-TX
100Base-FX
Catalyst 2950
SERIES
Switch with
inline power or
power patch panel
Access point
74329