Cisco Cisco Aironet 1810 OfficeExtend Access Point Guía De Instalación

Each Ethernet port has two LEDs for showing Link (Green) and Activity (Amber) statuses. They are 
integrated on the RJ45 connector. For a description of the statuses they indicate, see the following 
table. 

Using the Mode button you can:

Reset the AP to it’s default factory-shipped configuration.

Clear the AP’s internal storage, including all configuration files and the regulatory domain 
configuration.

The Mode button is located on the back of the AP (see 

). You need to remove the back cover 

of the AP to access the mode button (see 

).

To use the mode button, press, and keep pressed, the mode button on the access point during the AP's 
boot cycle. Wait until the AP's status LED changes to Amber. During this, the AP console shows a 
seconds counter, counting the number of seconds the mode button is pressed. Then:

To reset the AP to it’s default factory-shipped configuration, keep the mode button pressed for less 
than 20 seconds. The AP's configuration files are cleared. 

Cisco IOS errors

Red

Software failure. 

Try disconnecting and reconnecting power to the 
AP.

Cycling through Red, 
Green, Amber and off.

General warning. Insufficient inline power.

Off

Off

Off

Off

On

On

On

Blinking On

Blinking On

Blinking