Cisco Cisco SF302-08PP 8-port 10 100 PoE+ Managed Switch Manual De Mantenimiento
Smartport
Common Smartport Tasks
Cisco 300 Series Managed Switches Administration Guide
196
11
Common Smartport Tasks
This section describes some common tasks to setup Smartport and Auto
Smartport.
Smartport.
Workflow1: To globally enable Auto Smartport on the device, and to
configure a port with Auto Smartport, perform the following steps:
configure a port with Auto Smartport, perform the following steps:
STEP 1
To enable the Auto Smartport feature on the device, open the Smartport >
Properties page. Set Administrative Auto Smartport to Enable or Enable by Voice
VLAN.
Properties page. Set Administrative Auto Smartport to Enable or Enable by Voice
VLAN.
STEP 2
Select whether the device is to process CDP and/or LLDP advertisements from
connected devices.
connected devices.
STEP 3
Select which type of devices are to be detected in the Auto Smartport Device
Detection field.
Detection field.
STEP 4
Click Apply
STEP 5
To enable the Auto Smartport feature on one or more interfaces, open the
Smartport > Interface Settings page.
Smartport > Interface Settings page.
STEP 6
Select the interface, and click Edit.
STEP 7
Select Auto Smartport in the Smartport Application field.
STEP 8
Check or uncheck Persistent Status if desired.
STEP 9
Click Apply.
Workflow2: To configure an interface as a static Smartport, perform the
following steps:
following steps:
STEP 1
To enable the Smartport feature on the interface, open the Smartport > Interface
Settings page.
Settings page.
STEP 2
Select the interface, and click Edit.
STEP 3
Select the Smartport type that is to be assigned to the interface in the Smartport
Application field.
Application field.
STEP 4
Set the macro parameters as required.
STEP 5
Click Apply.