Cisco Cisco Packet Data Gateway (PDG) Guía Para Resolver Problemas
Service Configuration Procedures
Session Continuity Support ▀
Cisco ASR 5000 Series Access Service Network Gateway Administration Guide ▄
OL-22953-01
Step 3
Create the HA service by entering the following command:
ha_service_name is the name designated for the HA service. The name must be from 1 to 63 alpha and/or numeric
characters and is case sensitive.
characters and is case sensitive.
The following prompt appears:
Step 4
Configure the HA service for WiMAX calls only by entering:
Step 5
Return to the Exec mode by entering:
Step 6
Save your configuration as described in Saving Your Configuration.
When this configuration is enabled, the system will support only WiMAX HA behavior for the particular HA-service.
The system always expects WiMAX MIP keys from AAA and uses them to do MN-HA and FA-HA Authentication
extension. With this configuration, HA cannot support calls with static keys for MIP RRQ authentication in the
particular HA service.
The system always expects WiMAX MIP keys from AAA and uses them to do MN-HA and FA-HA Authentication
extension. With this configuration, HA cannot support calls with static keys for MIP RRQ authentication in the
particular HA service.
Configuring WiMAX HA to Accept 3GPP2/Static MIP Key
This section provides instructions for configuring HA services to accept 3GPP2 calls and disable the use of AAA-
provided WiMAX MIP keys for authenticating MIP RRQs. These instructions assume that you are at the root prompt
for the Exec mode:
provided WiMAX MIP keys for authenticating MIP RRQs. These instructions assume that you are at the root prompt
for the Exec mode:
Step 1
Enter the configuration mode by entering:
The following prompt appears: