Cisco Cisco Packet Data Interworking Function (PDIF) Guía Para Resolver Problemas
Access Control Lists
▀ Applying IP ACLs
▄ Cisco ASR 5000 Series Enhanced Feature Configuration Guide
OL-22983-01
Applying an ACL to an Individual Subscriber
IP ACLs are applied to subscribers via attributes in their profile. The subscriber profile could be configured locally on
the system or remotely on a RADIUS server.
the system or remotely on a RADIUS server.
To apply an ACL to a RADIUS-based subscriber, use the
attribute. Refer to the AAA Interface
Administration and Reference for more detail on this attribute.
This section provides information and instructions for applying an ACL to an individual subscriber whose profile is
configured locally on the system.
configured locally on the system.
Important:
It is recommended that all ACLs be configured and verified according to the instructions in the
that the subscribers have been previously configured.
Important:
This section provides the minimum instruction set for applying the ACL list to all traffic within a
context. For more information on commands that configure additional parameters and options, refer Subscriber
Configuration Mode Commands chapter in Command Line Interface Reference.
Configuration Mode Commands chapter in Command Line Interface Reference.
To configure the system to provide access control list facility to subscribers:
Step 1
Apply the configured access control list by applying the example configuration in the
Step 2
Verify that ACL is applied properly on interface by following the steps in the
Step 3
Save your configuration as described in the Verifying and Saving Your Configuration chapter.
Applying ACL to an Individual Subscriber
To apply the ACL to an individual subscriber, use the following configuration: