Cisco Cisco Aironet 1400 Wireless Bridge Notas de publicación
2
Release Notes for Cisco Aironet 1410 Wireless Bridges for Cisco IOS Release 12.3(11)JA
OL-11202-01
Introduction
Introduction
The Cisco Aironet 1400 Series Bridge is a wireless device designed for building-to-building wireless
connectivity. Operating in the 5.8-GHz UNII 3 band (5725 to 5825 MHz), derived from the 802.11a
standard, the bridge delivers 6 to 54 Mbps data rates without the need for a license. The bridge is a
self-contained unit designed for outdoor installations, providing differing antenna gains as well as
coverage patterns and supports both point-to-point and point-to-multipoint configurations.
connectivity. Operating in the 5.8-GHz UNII 3 band (5725 to 5825 MHz), derived from the 802.11a
standard, the bridge delivers 6 to 54 Mbps data rates without the need for a license. The bridge is a
self-contained unit designed for outdoor installations, providing differing antenna gains as well as
coverage patterns and supports both point-to-point and point-to-multipoint configurations.
The bridge uses a browser-based management system, but you can also configure the bridge using the
command-line interface (CLI) through a Telnet session, Cisco IOS commands, or Simple Network
Management Protocol (SNMP).
command-line interface (CLI) through a Telnet session, Cisco IOS commands, or Simple Network
Management Protocol (SNMP).
System Requirements
You can install Cisco IOS Release 12.3(11)JA on all 1400 series bridges.
Finding the Software Version
To find the version of Cisco IOS software running on your bridge, use a Telnet session to log into the
bridge and enter the show version EXEC command. This example shows command output from a bridge
running Cisco IOS Release 12.3(7)JA:
bridge and enter the show version EXEC command. This example shows command output from a bridge
running Cisco IOS Release 12.3(7)JA:
bridge> show version
Cisco Internetwork Operating System Software
IOS (tm) C1410 Software (C1410-K9W7-M), Version 12.3(7)JA
Copyright (c) 1986-2003 by Cisco Systems, Inc.
You can also find the software version on the System Software Version page in the bridge’s web-browser
interface.
interface.
Upgrading to a New Software Release
For instructions on installing access point software for your access point:
Step 1
Follow this link to the Cisco home page:
Step 2
Click Technical Support and Documentation. The Technical Support and Documentation page
appears.
appears.
Step 3
Click Wireless. The Wireless Support Resources page appears.
Step 4
Scroll down to the Wireless LAN Access section.
Step 5
Click Cisco Aironet 1400 Series. The Cisco Aironet 1400 Series Introduction page appears.
Step 6
Under the Configure section, click Install and Upgrade Guides. A list of configuration documents
appears.
appears.
Step 7
Click Cisco Aironet 1400 Series Bridge Software Configuration Guide.
Step 8
Navigate to the Managing Firmware and Configurations chapter.