Cisco Cisco Aironet 1400 Wireless Bridge Notas de publicación

For information on Cisco IOS software, click this link to browse to the Cisco IOS Software Center on 
Cisco.com:

No new features for the bridge are introduced in Cisco IOS Release 12.3(11)JA.

This section contains important information to keep in mind when installing your bridge.

The bridge is available in two configurations:

Integrated antenna bridge (with 22.5-dBi directional antenna)

External antenna bridge (with antenna connector for use with a customer-supplied external antenna)

To meet regulatory restrictions, the external antenna bridge configuration and the external antenna must 
be professionally installed.

When installing the dual-coax cable, it is acceptable to unzip or pull the two cables apart at the ends if 
more separation is needed between the male F connectors. 

Personnel installing the bridge must understand wireless bridging techniques, antenna alignment and 
adjustment, and grounding methods. The integrated antenna configuration can be installed by an 
experienced IT professional. 

You can double the throughput or create a standby link by stacking two bridges. A stacked installation 
consists of two bridge systems installed at the same physical location. For detailed mounting instructions 
refer to the Cisco Aironet 1400 Series Wireless Bridge Mounting Instructions that shipped with your 
bridge.

The bridge antennas must be separated by a minimum of 6.56 ft (2 m) from each other and from other 
co-located antennas.