Cisco Cisco Aironet 350 Workgroup Bridges Guía De Instalación

You can mount the Access Point, base station, or bridge to a wall using the mounting kit and mounting 
template provided. The kit contains the following parts:

Two #6 - #8 plastic wall anchors

Two #6 x 3/4" sheet-metal screws

Use the mounting template to drill two holes in the wall. The holes should be 3/16 in. (0.48 cm) in 
diameter and 1 in. (2.54 cm) deep.

If you make a photocopy of the mounting template, make sure that the distance between the holes is 
4 3/4 in. (12.06 cm) before you drill the holes. Some photocopy machines do not make exact 
duplicates of the original.

Tap the wall anchors into the holes.

Drive the screws into the wall anchors, leaving a small gap between the screw head and the anchor.

Position the mounting holes on the bottom of the case over the screws (see 

) and pull down to 

lock in place.

Position the antenna so it is pointing straight up.

41870