Cisco Cisco Aironet 1310 Access Point Bridge Notas de publicación
5
Release Notes for Cisco Aironet Access Points and Bridges for Cisco IOS Release 12.4(25d)JA2
OL-23880-01
Important Notes
Antenna Installation
For instructions on the proper installation and grounding of external antennas for 1260 series access
points, refer to the National Fire Protection Association’s NFPA 70, National Electrical Code, Article
810, and the Canadian Standards Association’s Canadian Electrical Code, Section 54.
points, refer to the National Fire Protection Association’s NFPA 70, National Electrical Code, Article
810, and the Canadian Standards Association’s Canadian Electrical Code, Section 54.
Warning
Do not install the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
Important Notes
This section describes important information about access points and bridges.
Cisco Aironet 1040 and 1260 Series Access Points
The Cisco Aironet 1040 and 1260 Series Access Points are business-class access points based on the
IEEE 802.11n draft 2.0 standard. It provides reliable WLAN coverage to improve the end-user
experience for both existing 802.11a/b/g clients and new 802.11n clients. The access point offers
combined data rates of up to approximately 444.2 Mb/s to meet the most rigorous bandwidth
requirements. Users can now rely on wireless networks to deliver a similar experience to wired networks,
providing mobile access to high-bandwidth data, voice, and video applications, irrespective of their
location.
IEEE 802.11n draft 2.0 standard. It provides reliable WLAN coverage to improve the end-user
experience for both existing 802.11a/b/g clients and new 802.11n clients. The access point offers
combined data rates of up to approximately 444.2 Mb/s to meet the most rigorous bandwidth
requirements. Users can now rely on wireless networks to deliver a similar experience to wired networks,
providing mobile access to high-bandwidth data, voice, and video applications, irrespective of their
location.
Note
The c1260 access point uses the “ap3g1-k9w7-tar” image.
Note
The c1040 access point uses the same image as the c1140 access point, which is the “c1140-k9w7-tar”
image.
image.
Detailed information and configuration procedures for the 1040 and 1260 series access point are in
Chapter 6 of the Cisco IOS Software Configuration Guide for Cisco Aironet Access Points, 12.4(25d)JA1
& 12.3(8)JEE, which is available on Cisco.com at the following URL:
Chapter 6 of the Cisco IOS Software Configuration Guide for Cisco Aironet Access Points, 12.4(25d)JA1
& 12.3(8)JEE, which is available on Cisco.com at the following URL:
CLI for Framed Access Support
Framed attribute is supported with the Autonomous 1040 and 1260 Series Access Points. A new option
“framed” is added to the existing CLI “dot11 aaa authentication attributes service.” This allows you to
configure service types as “login” or “framed” depending on the user requirement. CLI syntax:
“framed” is added to the existing CLI “dot11 aaa authentication attributes service.” This allows you to
configure service types as “login” or “framed” depending on the user requirement. CLI syntax:
router(config-t) dot11 aaa authentication attribute service [login-user | framed-user]
By default the service type “login” is sent in the access request.