Cisco Cisco Aironet 1310 Access Point Bridge Notas de publicación
3
Release Notes for Cisco Aironet Access Points and Bridges for Cisco IOS Release 12.4(25d)JA2
OL-23880-01
System Requirements
Step 8
Navigate to the Managing Firmware and Software chapter.
For information on Cisco IOS software, click this link to browse to the Cisco IOS Software Center on
Cisco.com:
Cisco.com:
Disable Radios to Prevent Unexpected Reboot When Upgrading System Software
If your access point runs Cisco IOS Release 12.2(11)JA, 12.2(11)JA1, or 12.2(11)JA2, your access point
might unexpectedly reboot after you upgrade to a later Cisco IOS release. Because of a rare timing
condition that affects the radios, the access point sometimes reboots immediately after the upgrade when
the radios are enabled. However, after the access point reboots the upgrade is complete and the access
point operates normally. To prevent the access point from rebooting unexpectedly, disable the radio
interfaces before upgrading software.
might unexpectedly reboot after you upgrade to a later Cisco IOS release. Because of a rare timing
condition that affects the radios, the access point sometimes reboots immediately after the upgrade when
the radios are enabled. However, after the access point reboots the upgrade is complete and the access
point operates normally. To prevent the access point from rebooting unexpectedly, disable the radio
interfaces before upgrading software.
Follow these steps to disable the radio interfaces using the web-browser interface:
Step 1
Browse to the Network Interfaces: Radio Settings page.
shows the top portion of the Network
Interfaces: Radio Settings page.
Figure 1
Network Interfaces: Radio Settings Page
Step 2
Select Disable to disable the radio.