Cisco Cisco Aironet 350 Access Points Notas de publicación
3
Release Notes for Cisco Aironet 350, 1100, 1130AG, 1200, and 1230AG Series Access Points for Cisco IOS Release 12.3(2)JA
OL-6252-01
System Requirements
IOS (tm) C1200 Software (C1200-K9W7-M), Version 12.2(15)JA
Copyright (c) 1986-2004 by Cisco Systems, Inc.
On access points running IOS software, you can also find the software version on the System Software
Version page in the access point’s web-browser interface. If your access point does not run IOS software,
the software version appears at the top left of most pages in the web-browser interface.
Version page in the access point’s web-browser interface. If your access point does not run IOS software,
the software version appears at the top left of most pages in the web-browser interface.
Upgrading to a New Software Release
For instructions on installing access point software:
1.
Follow this link to the Cisco Aironet Install and Upgrade page:
2.
Click this link to browse to the Cisco IOS Software Center on Cisco.com:
Log into Cisco.com to use the Cisco IOS Upgrade Planner.
Disable Radios to Prevent Unexpected Reboot When Upgrading System Software
If your access point runs Cisco IOS Release 12.2(11)JA, 12.2(11)JA1, or 12.2(11)JA2, your access point
might unexpectedly reboot after you upgrade to a later Cisco IOS Release. Because of a rare timing
condition that affects the radios, the access point sometimes reboots immediately after the upgrade when
the radios are enabled. However, after the access point reboots the upgrade is complete and the access
point operates normally. To prevent the access point from rebooting unexpectedly, disable the radio
interfaces before upgrading software.
might unexpectedly reboot after you upgrade to a later Cisco IOS Release. Because of a rare timing
condition that affects the radios, the access point sometimes reboots immediately after the upgrade when
the radios are enabled. However, after the access point reboots the upgrade is complete and the access
point operates normally. To prevent the access point from rebooting unexpectedly, disable the radio
interfaces before upgrading software.
Follow these steps to disable the radio interfaces using the web-browser interface:
Step 1
Browse to the Network Interfaces: Radio Settings page.
shows the top portion of the Network
Interfaces: Radio Settings page.
Figure 1
Network Interfaces: Radio Settings Page
Step 2
Select Disable to disable the radio.