Cisco Cisco Aironet 350 Workgroup Bridges Notas de publicación

The following caveats were resolved in firmware version 8.89:

CSCee83100—Workgroup bridge does not automatically LEAP reauthenticate after a failure.

CSCea64630—Workgroup bridge resets to factory defaults by itself.

CSCed33613—Link tests parameter is reset to factory default by rebooting the workgroup bridge.

For the most up-to-date, detailed troubleshooting information, refer to the Cisco TAC website at this 
URL (select Product Support > Wireless > Wireless LAN):

This section describes errors, omissions, and changes in user documentation for workgroup bridges.

The workgroup bridge management system includes a wired LAN staleout time setting on the 
Configuration > Ethernet page. Use this setting to control the number of seconds that the workgroup 
bridge continues to track a device in its association table when the device is inactive. Enter a value 
between 5 and 1000 seconds. (Five minutes equals 300 seconds; ten minutes equals 600 seconds.)

If the same devices are always connected to the workgroup bridge, enter 5 for the staleout time setting. 
If the devices connected to the workgroup bridge change frequently, enter 300 (equal to five minutes) 
for the staleout time setting. If you disconnect the Ethernet cable from the workgroup bridge and 
reconnect it, the workgroup bridge removes all devices from its association table and relearns them, 
regardless of the staleout time setting.

Use the following documents with this document:

Cisco documentation and additional literature are available on Cisco.com. Cisco also provides several 
ways to obtain technical assistance and other technical resources. These sections explain how to obtain 
technical information from Cisco Systems.