Cisco Cisco Aironet 350 Workgroup Bridges Notas de publicación
F I R S T D R A F T - C I S C O C O N F I D E N T I A L
4
Release Notes for Cisco Aironet 350 Series Workgroup Bridges Running Firmware Release 8.89
OL-6341-01
Important Notes
Important Notes
Cisco Aironet Software Requires Completion of Encryption Authorization Form
To access Cisco Aironet software from the Software Center on Cisco.com, you must complete a form to
receive authorization to download encrypted software. Registered Cisco.com users are required to fill
out the form only once, while public users must do so once each session, each time software is
downloaded. A form is automatically created for public users. The form for registered Cisco.com users
is at the following URL:
receive authorization to download encrypted software. Registered Cisco.com users are required to fill
out the form only once, while public users must do so once each session, each time software is
downloaded. A form is automatically created for public users. The form for registered Cisco.com users
is at the following URL:
Bridge Loop Can Occur with Incorrect Network Topology
If the workgroup bridge is connected to the wired LAN and is communicating with an access point on
the same LAN, a network problem known as a bridge loop can occur. Avoid a bridge loop by
disconnecting the workgroup bridge from the wired LAN immediately after you configure it.
the same LAN, a network problem known as a bridge loop can occur. Avoid a bridge loop by
disconnecting the workgroup bridge from the wired LAN immediately after you configure it.
shows the network configuration in which the loop occurs.
Figure 1
Bridge Loop Caused by a Workgroup Bridge Connected to the Wired LAN
ETHERNET
SPEED
1
5
2
6
3
7
4
8
LED
100BaseTX
SOLID
10BaseT
BLINK
1X 2X
3X 4X
5X
6X
7X
MDI
MDI-X
8X
Wired LAN
Access point
Workgroup bridge
Hub
44712