Cisco Cisco Aironet 350 Wireless Bridge Guía Para Resolver Problemas
WLAN Radio Coverage Area Extension Methods
Document ID: 66091
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Methods You Can Use to Extend the Radio Coverage Area of the WLAN
Use APs in Repeater Mode
Use a Secondary AP in Access Point Mode with Non−overlapping Channels
Transmit Rate between the AP and Client
Change the Transmitter Power Level Parameter of the Existing AP to Extend the Coverage
Position the APs Optimally
Distance
Obstructions
Interference
Related Information
Prerequisites
Requirements
Components Used
Conventions
Methods You Can Use to Extend the Radio Coverage Area of the WLAN
Use APs in Repeater Mode
Use a Secondary AP in Access Point Mode with Non−overlapping Channels
Transmit Rate between the AP and Client
Change the Transmitter Power Level Parameter of the Existing AP to Extend the Coverage
Position the APs Optimally
Distance
Obstructions
Interference
Related Information
Introduction
This document explains four possible ways in which you can extend the radio coverage area in a WLAN
network.
network.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Configuration of Cisco Aironet Access Points (AP)
•
How to perform a site survey
•
Components Used
The information in this document is based on these software and hardware versions:
Cisco Aironet 1200 series APs that run Cisco IOS® software
•
Cisco Aironet client adapters
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.