Cisco Cisco Aironet 350 Wireless Bridge Guía Para Resolver Problemas
Figure 1 shows two Cisco Aironet APs, namely, AP A and AP B. AP A is connected to the wired network
(the root unit). Wireless clients are associated with AP A. AP A uses the SSID "Cisco" for communication.
(the root unit). Wireless clients are associated with AP A. AP A uses the SSID "Cisco" for communication.
You need to configure AP B in repeater mode in order to extend the radio coverage area. Both AP A and AP
B are configured to be in the same IP subnet.
B are configured to be in the same IP subnet.
Note: When you configure an AP as a repeater, ensure that these parameters on the repeater AP are different
from that of the root AP.
from that of the root AP.
IP address of the Repeater AP
1.
Station Role on the Repeater AP (must be Repeater)
2.
Configuration of AP B through the CLI
This section explains the step−by−step configuration required on AP B to set up the AP as a repeater.
Access Point B# configure terminal
!−−− Enter global configuration mode.
Access Point A(config)# interface BVI
Access Point A(config−if)# ip address 10.0.0.5 255.0.0.0
!−−− Configure an IP address for the bridge virtual interface (BVI) interface.
!−−− The repeater must be in the same subnet as the root AP.
Access Point B(config)# interface dot11radio 0
!−−− Enter interface configuration mode for the radio interface.
!−−− The 2.4 GHz radio is radio 0, and the 5 GHz radio is radio 1.