Cisco Cisco Aironet 350 Wireless Bridge Guía Para Resolver Problemas

9600 bps

• 

8 data bits

• 

No parity

• 

1 stop bit

• 

No (NONE) flow control

• 

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Your AP must run VxWorks firmware version 11.40T or later in order to install VxWorks firmware version
12.05.

Refer to the Resetting the Configuration section of Managing Firmware and Configurations if you need to set
the unit back to factory defaults.

The Upgrade procedure explained in this section is with respect to the boot block version 0.05 on the AP. The
procedure to upgrade the 12.01T1 firmware is the same, regardless of the boot block version available on your
AP.

You need to unplug and replug the power connector to reboot the AP. This determines the boot block version
available on your AP.

As the AP reboots, the introductory system information appears. The boot block version appears in the third
line of this text and is labeled 

Bootstrap Ver

. This output shows the bootstrap version 0.05 that appears:

System ID: 000ED77C343E

Motherboard: IBM405 200MHz, 8192KB FLASH, 16384KB DRAM, Revision 00

Bootstrap Ver. 0.05: FLASH, CRC C5CA9B6B (OK)

Initialization: OK

Complete these steps to upgrade your AP:

When the memory files are listed under the heading of 

Memory:File

, press Ctrl−W within five

seconds to reach the boot block menu.

1. 

Press = (the equal sign key) to go to the main menu.

c −− Copy file

f −− File dir

2.