Cisco Cisco Aironet 1310 Access Point Bridge Guía De Instalación
Corporate Headquarters:
Copyright © 2006 Cisco Systems, Inc. All rights reserved.
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Read Me First For Cisco Aironet 1300 Series
Lightweight Access Points
Lightweight Access Points
June 2006
Manually Configuring Controller Information
In a new installation, when your new lightweight access point (Model number: AIR-LAP1310G) is
unable to reach a DHCP server, you can manually configure static controller information using the power
injector console port and EXEC mode CLI commands. The static settings configured with the CLI
commands are used by the lightweight access point to connect with a controller.
unable to reach a DHCP server, you can manually configure static controller information using the power
injector console port and EXEC mode CLI commands. The static settings configured with the CLI
commands are used by the lightweight access point to connect with a controller.
Note
These CLI commands can be used only on lightweight access points that are not associated to a
controller.
controller.
Console Port
You can use the power injector’s console port for entering CLI commands to manually configure
controller information. Follow these steps to connect to the power injector’s console port:
controller information. Follow these steps to connect to the power injector’s console port:
Step 1
Connect a nine-pin, female DB-9 to RJ-45 serial cable to the RJ-45 serial console port on the power
injector and to the COM port on a computer.
injector and to the COM port on a computer.
Note
The Cisco part number for the DB-9 to RJ-45 serial cable is AIR-CONCAB1200. Browse to
to order a serial cable.
Step 2
Set up a terminal emulator, such as Windows Hyper Terminal, to communicate with the access point.
Use the following settings: 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.
Use the following settings: 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.