Cisco Cisco Aironet 350 Access Points Notas de publicación

The Aironet Access Point MIB file (AWCVX-MIB) is supported by Access Point firmware versions 
11.00 and later. Earlier versions of firmware do not support this MIB.

You must enable Aironet extensions on the AP Radio Advanced page when you set up the Access Point 
as a repeater. If you disable Aironet extensions when in repeater mode, connect a serial cable to the 
Access Point and enable Aironet extensions with the console interface.

If you are a Cisco registered user, you can use the Cisco TAC Software Bug Toolkit, which consists of 
three tools (Bug Navigator, Bug Watcher, and Search by Bug ID Number) that help you identify existing 
bugs (or caveats) in Cisco software products. 

Access the TAC Software Bug Toolkit today at http://www.cisco.com/support/bugtools/.

The following caveats have been resolved in firmware version 11.02:

350 Series Access physical layer incompatible with firmware version 11.01.

Firmware version 11.02 solves a physical layer incompatibility problem on 350 series Access 
Points. The 340 series does not have this incompatibility problem, so an upgrade from 11.01 to 11.02 
will not add any features or benefits for 340 series Access Points.

The following caveats have not been resolved for firmware version 11.02:

Difficult to end Telnet session (CSCav00156).

When you finish running a Telnet session to the Access Point you must close the Telnet window to 
end the session.

Network response times might be slow on networks with thousands of client devices (CSCdr95686).

On large, flat networks with thousands of client devices, the Access Point might respond slowly to 
network traffic. Segmenting the network into subnets can improve Access Point performance.