Cisco Cisco Aironet 350 Workgroup Bridges Guía De Instalación

In the row in the Privacy menu labeled Encrypt radio packets, click on, mixed on, or mixed 

off to select the WEP category for the bridge.

— Off is the default setting, which means that the bridge will not communicate with an 

access point using WEP. 

— On means that the bridge will communicate only with access points that use WEP.

— Mixed  on means that the bridge will always use WEP when communicating with the 

access point, but that the access point will communicate with all devices whether they 

use WEP or not. 

— Mixed  off means that the bridge will not use WEP when communicating with the 

access point, but the access point will communicate with all devices whether they use 

WEP or not.

In the Configuration menu, click Identity.

In the System name entry field, enter a network label for the bridge and click Save. This 

name will identify the bridge in the association table on any access point. 

Follow these steps to configure the bridge using a Telnet session:

On your computer’s Start menu, select Programs > Accessories > Telnet. 

If Telnet is not listed in your Accessories menu, select Start > Run, type Telnet in the entry 

field, and press Enter. 

When the Telnet window appears, click Connect and select Remote System.

In Windows 2000, the Telnet window does not contain pull-down menus. To start the 

Telnet session in Windows 2000, type open followed by the bridge’s IP address and skip to 

Step 4.

In the Host Name field, type the bridge’s IP address provided by the IP Finder utility. Click 

Connect.