Cisco Cisco Aironet 350 Workgroup Bridges Guía De Instalación

Type 1 to select Configuration. When the configuration menu appears, type 1 again to 

select Radio. When the radio menu appears, type 1 again to select SSID.

If you are configuring the bridge through a wireless connection, changing 

the SSID in the next step could interrupt connectivity to the device. Take care to enter 

an SSID that matches the SSID of an access point near the bridge.

Look at the current SSID. If it is tsunami, the default setting, enter the SSID provided by 

your network administrator on the data entry line and press Enter.

If you already set the SSID using IPSU and the current SSID is correct, you do not need to 

set it again. 

Steps 6 through 13 help you set the bridge’s WEP key. If your wireless network does not 

use WEP, skip to Step 15.

Type 5 to select I80211. When the I80211 menu appears, type 2 to select Privacy.

In the Privacy menu, type 3 to select Key.

Enter the WEP key number your network administrator asked you to set and press Enter.

Enter the key provided by your network administrator and press Enter. If you are setting a 

40-bit key, enter 10 hexadecimal characters (any combination of 0 through 9, a through f, 

or A through F). If you are setting a 128-bit key, enter 26 hexadecimal characters. You are 

prompted to re-enter the key for verification. Type the key and press Enter.

Type 4 to select Transmit. 

Enter the number of the key the bridge will use and press Enter. Only one WEP key can be 

used at a time.

The WEP key you use to transmit data must be set up exactly the same on your access 

point and your bridge. For example, if you set WEP Key 3 on your bridge to 0987654321 and 

select it as the transmit key, you must also set WEP Key 3 on the access point to 0987654321.