Cisco Cisco Aironet 350 Access Points Notas de publicación
2
Release Notes for Cisco Aironet 340 and 350 Series Access Points and 350 Series Bridges Running VxWorks Firmware Version 12.04
OL-5157-01
Introduction
Introduction
A Cisco Aironet Access Point is a wireless LAN transceiver that can act as the connection point between
wireless and wired networks or as the center point of a standalone wireless network. Cisco Aironet
Bridges are wireless LAN transceivers that connect two or more remote networks into a single LAN.
wireless and wired networks or as the center point of a standalone wireless network. Cisco Aironet
Bridges are wireless LAN transceivers that connect two or more remote networks into a single LAN.
The access point and bridge use a browser-based management system. The system settings are on web
pages in the system firmware. You use your Internet browser to view and adjust the system settings.
pages in the system firmware. You use your Internet browser to view and adjust the system settings.
Installation Notes
You can find the latest release of access point and bridge firmware at this URL:
Invalid Console Message on Reboot
When upgrading to 12.04 from an earlier version, the following console message appears when the
system reboots:
system reboots:
Inflating EnterpriseAP Sys 12.03...
The message is invalid and should be ignored.
Installation in Environmental Air Space
Cisco Aironet 350 Series Bridges and metal-case access points are suitable for use in environmental air
space in accordance with Section 300-22(c) of the National Electrical Code.
space in accordance with Section 300-22(c) of the National Electrical Code.
Caution
The Cisco Aironet Power Injector has a smaller operating temperature range (32 to 104
o
F; 0 to 40
o
C)
than the 350 series bridge and metal-case access point. The power injector is not intended for use in
extremely high or low temperatures or in environmental air spaces, such as above suspended ceilings.
extremely high or low temperatures or in environmental air spaces, such as above suspended ceilings.
Antenna Installation
For instructions on the proper installation and grounding of external antennas, refer to the National Fire
Protection Association’s NFPA 70, National Electrical Code, Article 810, and the Canadian Standards
Association’s Canadian Electrical Code, Section 54.
Protection Association’s NFPA 70, National Electrical Code, Article 810, and the Canadian Standards
Association’s Canadian Electrical Code, Section 54.
Warning
Do not locate the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.