Cisco Cisco Aironet 350 Wireless Bridge Manual Técnica

its credentials to the infrastructure AP when it comes up for the first time. The infrastructure AP then forwards
the same to the WDS AP, which validates the credentials.

Note:  This document does not explain how to configure the client adapter. Refer to Cisco Aironet Wireless
LAN Client Adapters for information on how to configure the client adapter.

Use this section to confirm that your configuration works properly.

show wlccp wds mn − Use this command from the CLI on the WDS AP to verify successful client
authentication and association with the WDS AP.

• 

WDS#show wlccp wds mn

  MAC−ADDR         IP−ADDR      Curr−AP          STATE

 0040.96a5.b5d4    10.0.0.15    000e.d7e4.a629  REGISTERED

The following debug commands are also helpful.

debug wlccp ap { mn | wds−discovery | state } − Use this command to turn on display of debug
messages related to client devices (mn), the WDS discovery process, and access point authentication
to the WDS access point (state).

• 

debug wlccp packet − Use this command to turn on display of packets to and from the WDS access
point.

• 

debug radius local−server − Activates display of error messages related to failed client
authentications to the local authenticator

• 

There is currently no specific troubleshooting information available for this configuration.

• 

• 

• 

• 

• 

• 

Contacts & Feedback | Help | Site Map
© 2014 − 2015 Cisco Systems, Inc. All rights reserved. Terms & Conditions | Privacy Statement | Cookie Policy | Trademarks of
Cisco Systems, Inc.

Updated: Jan 18, 2007

Document ID: 68098