Cisco Cisco Packet Data Interworking Function (PDIF) Guía De Administador
System Interfaces and Ports
Ethernet Interfaces and Ports ▀
Cisco ASR 5000 System Administration Guide ▄
99
Viewing and Verifying Port Configuration
Step 1
Verify that your interface configuration settings are correct by entering the following commands:
context context_name
show { ip | ipv6 } interface
context_name
represents the name of the context in which the interface was created. The output from these commands
should be similar to the following example.
In this example an interface named mgmt1 was configured in the local context.
Intf Name: mgmt1
Intf Type: Broadcast
IP State: UP (Bound to 17/1 untagged, ifIndex 285278209)
IP State: UP (Bound to 5/11 untagged, ifIndex 285278209)
IP Address: 192.168.100.3 Subnet Mask: 255.255.255.0
Bcast Address: 192.168.100.255 MTU: 1500
Resoln Type: ARP ARP timeout: 3600 secs
L3 monitor LC-port switchover: Disabled
Number of Secondary Addresses: 0
Total interface count: 1
Intf Type: Broadcast
IP State: UP (Bound to 17/1 untagged, ifIndex 285278209)
IP State: UP (Bound to 5/11 untagged, ifIndex 285278209)
IP Address: 192.168.100.3 Subnet Mask: 255.255.255.0
Bcast Address: 192.168.100.255 MTU: 1500
Resoln Type: ARP ARP timeout: 3600 secs
L3 monitor LC-port switchover: Disabled
Number of Secondary Addresses: 0
Total interface count: 1
Step 2
Verify that your port configuration settings are correct by entering the following command:
show configuration port slot#/port#
slot# is the chassis slot number of the line card on which the physical port resides. slot# can be any integer value from
17 to 39, and 42 to 48.
17 to 39, and 42 to 48.
This command produces an output similar to that displayed in the following example that shows the configuration for
port 1 on the line card installed in chassis slot 17.
port 1 on the line card installed in chassis slot 17.
In this example, the port is bound to an interface called rp1 configured in a context called source.
config
port ethernet 17/1
description LC17/1_RP1
no shutdown
bind interface rp1 source
#end
port ethernet 17/1
description LC17/1_RP1
no shutdown
bind interface rp1 source
#end
Step 3
Verify that your static route(s) was configured properly by entering the following command:
show ip static-route
This command produces an output similar to that displayed in the following example that shows a static route to a
gateway with an IP address of 192.168.250.1.
gateway with an IP address of 192.168.250.1.
Destination Nexthop Protocol Prec Cost Interface
0.0.0.0/0 192.168.250.1 Static 0 0 SPIO1
0.0.0.0/0 192.168.250.1 Static 0 0 rp1 source
0.0.0.0/0 192.168.250.1 Static 0 0 SPIO1
0.0.0.0/0 192.168.250.1 Static 0 0 rp1 source
Step 4
Save the configuration as described in the Verifying and Saving Your Configuration chapter.