Cisco Cisco Packet Data Interworking Function (PDIF)
Management Settings
SNMP Support ▀
ASR 5500 System Administration Guide, StarOS Release 18 ▄
87
SNMP Support
The system uses the SNMP to send traps or events to the EMS server or an alarm server on the network. You must
configure SNMP settings to communicate with those devices.
configure SNMP settings to communicate with those devices.
Important:
Commands used in the configuration samples in this section provide base functionality. The most
common commands and keyword options are presented. In many cases, other optional commands and keyword options
are available. Refer to the Command Line Interface Reference for complete information.
are available. Refer to the Command Line Interface Reference for complete information.
The SNMP MIB Reference describes the MIBs and SNMP traps supported by the ASR 5x00 platform.
To configure the system to communicate with the EMS server or an alarm server:
Step 1
Set SNMP parameters such as UDP port, and alarm server target by applying the example configuration in
Step 2
Step 3
Save the configuration as described in Verifying and Saving Your Configuration.
Configuring SNMP and Alarm Server Parameters
Use the following example to set SNMP and alarm server parameters:
configure
system contact contact_name
system location location_name
snmp authentication-failure-trap
snmp community community_string
snmp server port port_number
snmp target name ip_address
snmp engine-id local id_string
snmp notif-threshold value low low_value period time_period
snmp user user_name
snmp mib mib_name
snmp runtime-debug [ debug-tokens token_id token_id token_id...token_id
end