Cisco Cisco Packet Data Gateway (PDG)
Exec Mode Commands (D-S)
diameter reset connection ▀
Command Line Interface Reference, StarOS Release 18 ▄
4085
diameter reset connection
Resets individual TCP/SCTP connections for a specified Diameter endpoint.
Product
All
Privilege
Security Administrator, Administrator, Operator, Inspector
Mode
Exec
The following prompt is displayed in the Exec mode:
[local]host_name#
Syntax
diameter reset connection { endpoint endpoint_name peer peer_id }
endpoint endpoint_name
Resets connection to the endpoint specified as an alphanumeric string of 1 through 63 characters.
peer peer_id
Resets connection to the Diameter peer host name specified as an alphanumeric string of 1 through 63
characters.
characters.
Usage
Use this command to reset the TCP/SCTP connections for the specified endpoint/peer. With this command,
the connection will be closed temporarily after DPR/DPA. If there is any traffic to be sent to the particular
peer, then the connection will be re-established.
This command overrides the endpoint configured in any other configuration mode.
This command is applicable only when the specified peer is enabled.
the connection will be closed temporarily after DPR/DPA. If there is any traffic to be sent to the particular
peer, then the connection will be re-established.
This command overrides the endpoint configured in any other configuration mode.
This command is applicable only when the specified peer is enabled.
Example
This command resets connection to the endpoint named
test123
:
diameter reset connection endpoint test123