Cisco Cisco Packet Data Gateway (PDG)
ACS Rulebase Configuration Mode Commands
▀ edr transaction-complete
▄ Command Line Interface Reference, StarOS Release 18
690
edr transaction-complete
This command enables/disables the generation of an EDR on the completion of a transaction.
Important:
This command is available only in StarOS 8.1 and in StarOS 9.0 and later releases.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
In StarOS 12.2 and later releases:
edr transaction-complete http [ charging-edr charging_edr_format_name | edr-format
edr_format_name | reporting-edr reporting_edr_format_name ]
edr_format_name | reporting-edr reporting_edr_format_name ]
{ default | no } edr transaction-complete
In StarOS 12.1 and earlier releases:
edr transaction-complete http edr-format edr_format_name
{ default | no } edr transaction-complete
default
Configures this command with its default setting.
Default: Disabled; same as
Default: Disabled; same as
no edr transaction-complete
no
If previously configured, deletes the configuration from the current rulebase.
edr-format edr_format_name
Important:
This option is available only in 12.1 and earlier releases. In 12.2 and later releases, this option is
deprecated and is replaced by the
charging-edr
option.
Specifies to generate EDR on transaction completion, for HTTP protocol.
edr_format_name
must be the name of an EDR format, and must be an alphanumeric string of 1 through 63
characters.