Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Ruledef Configuration Mode Commands
▀ rtcp jitter
▄ Command Line Interface Reference, StarOS Release 18
1052
rtcp jitter
This command allows you to define rule expressions to match the jitter parameter in RTCP packets.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-ruledef)#
Syntax
[ no ] rtcp jitter operator jitter
no
If previously configured, deletes the specified rule expression from the current ruledef.
operator
Specifies how to match.
operator
must be one of the following:
!=
: Does not equal
<=
: Lesser than or equals
=
: Equals
>=
: Greater than or equals
jitter
Specifies the RTCP inter-arrival jitter value (in milliseconds) to match.
jitter
must be an integer from 0 through 4294967295.
Usage
Use this command to define rule expressions to match jitter parameter found in the RTCP sender report or
receiver report packets.
receiver report packets.
Example
The following command matches packets for jitter greater than or equal to 1295 milliseconds:
rtcp jitter >= 1295