Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Ruledef Configuration Mode Commands
▀ rtcp pdu-length
▄ Command Line Interface Reference, StarOS Release 18
1054
rtcp pdu-length
This command allows you to define rule expressions to match Protocol Data Unit (PDU) length of RTCP packets,
(RTCP header + RTCP payload).
(RTCP header + RTCP payload).
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-ruledef)#
Syntax
[ no ] rtcp pdu-length operator pdu_length
no
If previously configured, deletes the specified rule expression from the current ruledef.
operator
Specifies how to match.
operator
must be one of the following:
!=
: Does not equal
<=
: Lesser than or equals
=
: Equals
>=
: Greater than or equals
pdu_length
Specifies the RTCP length (in bytes) to match.
In 8.1 and later releases,
In 8.1 and later releases,
pdu_length
must be an integer from 1 through 65535.
In 8.0,
pdu_length
must be an integer from 1 through 2000.
Usage
Use this command to define rule expressions to match RTCP PDU length (header + payload) in bytes.
Example
The following command defines a rule expression to match user traffic based on an RTCP PDU length of
10000
bytes:
rtcp pdu-length = 10000