Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (T-threshold phspc)
▀ task facility mmemgr
▄ Command Line Interface Reference, StarOS Release 18
5584
task facility mmemgr
This command scales up or down the number of MMEMgrs per PSC3/DPC/SF-VM.
Important:
At this time, this command continues to be in development. The command is qualified for MMEs on
the SR 5000 platform with Normal Density as the current recommended setting.
Product
MME
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
task facility mmemgr per-sesscard-density { high | normal }
default task facility mmemgr per-sesscard-density
default
Resets the task facility mmegr to normal density per session card/VM.
per-sesscard-density { high | normal }
Important:
This is a boot-time configuration and should be added in the configuration file before any MME
service releated configuration is created or any MME Manager is started. Run-time (dynamic) configuration should be
saved and will take effect only after reboot.
saved and will take effect only after reboot.
This keyword sets the maximum number (density) of MMEmgrs per session card. The two options are:
high
for High Density, which allows for eNB scaling and provides for a lower number of session
cards. Currently, a maximum of 2 MMEMgrs per active session card.
normal
for Normal Density, the default model, which supports a max of 1 MMEMgr per active
session card.
Usage
It is expected that this command will develop further to take advantage of higher capacity (e.g., the
ASR5500) and next generation (e.g., the VPC-DI) platforms.
ASR5500) and next generation (e.g., the VPC-DI) platforms.
Example
Use a command similar to the following to set a maximum of 2 MMEMgrs :