Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (T-threshold phspc)
threshold asngw-auth-failure ▀
Command Line Interface Reference, StarOS Release 18 ▄
5611
threshold asngw-auth-failure
Configures authentication failure, alarm or alert thresholds for the ASN-GW system.
Product
ASN-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold asngw-auth-failure high_thresh [ clear low_thresh ]
default threshold asngw-auth-failure
high_thresh
Default: 0
Specifies the high threshold number of authentication failures that must be met or exceeded within the polling
interval to generate an alert or alarm.
Specifies the high threshold number of authentication failures that must be met or exceeded within the polling
interval to generate an alert or alarm.
high_thresh
is an integer from 0 through 10000000. A value of 0 disables the threshold.
clear
low_thresh
Default: 0
Specifies the low threshold number of authentication failures that maintains a previously generated alarm
condition. If the number of failures falls beneath the low threshold within the polling interval, a clear alarm
will be generated.
Specifies the low threshold number of authentication failures that maintains a previously generated alarm
condition. If the number of failures falls beneath the low threshold within the polling interval, a clear alarm
will be generated.
low_thresh
is an integer from 0 through 10000000. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Use this command to configure threshold limits to generate alerts or alarms based on the number of failed
ASN-GW authentication message requests that occur during the specified polling interval. Authentication
requests are counted for all ASN Gateway authentication servers with which that the system is configured to
communicate.
Alerts or alarms are triggered for authentication failures based on the following rules:
ASN-GW authentication message requests that occur during the specified polling interval. Authentication
requests are counted for all ASN Gateway authentication servers with which that the system is configured to
communicate.
Alerts or alarms are triggered for authentication failures based on the following rules:
Enter condition: Actual number of failures is greater than or equal to the high threshold.
Clear condition: Actual number of failures is less than the low threshold.