Cisco Cisco Packet Data Interworking Function (PDIF)
LTE Policy Configuration Mode Commands
▀ henbgw mme-pool
▄ Command Line Interface Reference, StarOS Release 18
7160
henbgw mme-pool
Creates or configures a specified MME or MME pool to which the HeNB-GW is to communicate and enters the MME
pool configuration mode.
pool configuration mode.
Product
HeNB-GW
Privilege
Administrator
Mode
Exec > Global Configuration > LTE Policy Configuration
configure > lte-policy
Entering the above command sequence results in the following prompt:
[local]host_name(lte-policy)#
Syntax
[ no ] henbgw mme-pool pool_name [ -noconfirm ]
no
Removes an already configured MME or MME pool from the system.
pool_name
Specifies the name of the MME pool being created or accessed. If the pool name does not refer to an existing
profile, a new pool is created.
profile, a new pool is created.
pool_name
is an alphanumeric string of 1 through 63 characters.
-noconfirm
Executes the command without any additional prompt and confirmation from the user.
Usage
Use this command to enter the MME Pool Configuration Mode for an existing pool or for a newly defined
MME pool. This command is also used to remove an existing MME pool.
MME pool. This command is also used to remove an existing MME pool.
Important:
A maximum of eight MME pools are allowed per system.
Entering this command results in the following prompt:
[context_name]hostname(mme-pool)#
MME Pool Configuration Mode commands are defined in the MME Pool Configuration Mode Commands
chapter.
chapter.
Example
The following command helps entering the MME Pool Configuration Mode for a new or existing profile
named
named
henb_mme_pool
: