Cisco Cisco Packet Data Interworking Function (PDIF)
LTE Policy Configuration Mode Commands
▀ henbgw overload-control
▄ Command Line Interface Reference, StarOS Release 18
7162
henbgw overload-control
Configures HeNBGW overload control parameters.
Product
HeNBGW
Privilege
Administrator
Mode
Exec > Global Configuration > LTE Policy Configuration
configure > lte-policy
Entering the above command sequence results in the following prompt:
[local]host_name(lte-policy)#
Syntax
henbgw overload-control [ load-reduction-indicator percentage_value | ochl-guard-time
minutes ]
minutes ]
default henbgw overload-control [ load-reduction-indicator | ochl-guard-time ] ]
default
Sets/Restores the default values assigned to HeNBGW overload control parameters. The default value of load
Reduction indication is 99 percent.
Reduction indication is 99 percent.
load-reduction-indicator percentage_value
Designates the percentage of HeNBs to relay overload start message if traffic load Reduction indication IE is
not present in the overload start message.
not present in the overload start message.
percentage_value
is the percentage value, which is an integer between 1 and 99.
ochl-guard-time minutes
Designates the guard timeout value for sending overload stop messages if overload stop message is not
received from MME to all the HeNBs in corresponding MME’s overload control HeNBs list.
received from MME to all the HeNBs in corresponding MME’s overload control HeNBs list.
minutes
is the number of minutes, which is an integer between 0 and 2147483647.
Usage
Use this command to configure HeNBGW overload control parameters.
Example
The following command configures HeNBGW overload control parameter
ochl-guard-time
as 45
minutes:
henbgw overload-control ochl-guard-time 45