Cisco Cisco Packet Data Interworking Function (PDIF)
SBc Service Configuration Mode Commands
bind ▀
Command Line Interface Reference, StarOS Release 18 ▄
8421
bind
Binds the SBc service to a local SCTP IP address. This interface is used by the SBc service to communicate with the
Cell Broadcast Center (CBC).
Cell Broadcast Center (CBC).
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > SBc Service Configuration
configure > context context_name > sbc-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-sbc-service)#
Syntax
bind { ipv4-address ipv4_address_value1 [ ipv4-address ipv4_address_value2 ] | ipv6-
address ipv6_address_value1 [ ipv6-address ipv6_address_value2 ]
address ipv6_address_value1 [ ipv6-address ipv6_address_value2 ]
no bind
no
Removes the interface binding from this SBc service.
ipv4-address ipv4_address_value1 [ ipv4-address ipv4_address_value2 ]
Specifies the IPv4 address of an interface in the current context through which communication with the CBC
occurs.
A second IPv4 address can be specified for multi-homing purposes with the optional
occurs.
A second IPv4 address can be specified for multi-homing purposes with the optional
ipv4-address
keyword.
ipv6-address ipv6_address_value1 [ ipv6-address ipv6_address_value2 ]
Specifies the IPv6 address of an interface in the current context through which communication with the CBC
occurs.
A second IPv6 address can be specified for multi-homing purposes with the optional
occurs.
A second IPv6 address can be specified for multi-homing purposes with the optional
ipv6-address
keyword.
Usage
Use this command to bind the SBc service to an IP address.
The command is service critical; removing the configuration will stop the SBc service.
Up to two IPv4 or two IPv6 addresses can be specified for multi-homing purposes.
Refer to the
The command is service critical; removing the configuration will stop the SBc service.
Up to two IPv4 or two IPv6 addresses can be specified for multi-homing purposes.
Refer to the
sbc-mme
command in this chapter to specify the SCTP port number to be used.
Example
The following command configures 2 IPv4 addresses for the SCTP connection (for multi homing):