Cisco Cisco Packet Data Interworking Function (PDIF)
Service Redundancy Protocol Configuration Mode Commands
▀ internal-switchover-retry-interval
▄ Command Line Interface Reference, StarOS Release 18
8484
internal-switchover-retry-interval
Defines the interval between internal switchover retries.
Product
All products supporting ICSR
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Service Redundancy Protocol Configuration
configure > context context_name > service-redundancy-protocol
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-srp)#
Syntax
internal-switchover-retry-interval interval
default internal-switchover-retry-interval
default
Resets the internal switchover retry interval to the default setting of 60 seconds.
interval
Specifies the amount of time (in seconds) between internal switchover retries.
interval
must be an integer
from 10 through 120. Default = 60.
Usage
This configures the interval between internal switchover retries. The system only initiates internal
switchovers if Service Redundancy Protocol (SRP) monitoring is configured.
switchovers if Service Redundancy Protocol (SRP) monitoring is configured.
Important:
See the
monitor authentication-probe
,
monitor bgp
, or
monitor diameter
commands
for more information on associated SRP monitoring.
Example
The following example sets the internal switchover retry interval to 34 seconds:
internal-switchover-retry-interval 34