Cisco Cisco Packet Data Interworking Function (PDIF)
ATM Port Configuration Mode Commands
threshold high-activity ▀
Command Line Interface Reference, StarOS Release 17 ▄
1589
threshold high-activity
Configures the port’s high and low activity thresholds.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > ATM Port Configuration
configure > port atm slot_number/port_number
Entering the above command sequence results in the following prompt:
[local]host_name(config-port-slot_number/port_number)#
Syntax
threshold high-activity high_thresh [ clear low_thresh ]
default threshold high-activity
default
Restores both port high-activity thresholds to the system default of 50 percent.
high_thresh
Default: 50
Sets the threshold for the highest percentage of port activity that must be met or exceeded, within the polling
interval, to generate an alert or alarm.
Sets the threshold for the highest percentage of port activity that must be met or exceeded, within the polling
interval, to generate an alert or alarm.
high_thresh_%
can be configured to any integer value between 0 and 100.
clear
low_thresh
Default: 50
Sets the threshold for the lowest percentage level of port activity that must be met to generate and send a clear
alarm. If port activity does not drop to or below this threshold then the alarm is maintained.
Sets the threshold for the lowest percentage level of port activity that must be met to generate and send a clear
alarm. If port activity does not drop to or below this threshold then the alarm is maintained.
low_thresh_%
can be configured to any integer value between 0 and 100.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
High port activity thresholds generate alerts or alarms based on the utilization percentage of each configured
port during the specified polling interval. This threshold is configured on a per-port basis.
Alerts or alarms are triggered for high port activity based on the following rules:
port during the specified polling interval. This threshold is configured on a per-port basis.
Alerts or alarms are triggered for high port activity based on the following rules:
Enter condition: Actual percent utilization of a port > High Threshold
Clear condition: Actual percent utilization of a port < Low Threshold