Cisco Cisco Packet Data Interworking Function (PDIF)
IuPS Service Configuration Mode Commands
inter-rnc-procedures ▀
Command Line Interface Reference, StarOS Release 17 ▄
6753
inter-rnc-procedures
This command enables the processing of SRNS relocation when the source RNC is behaving as the target RNC
Product
SGSN
Insert product and tag this paragraph appropriately.
Mode
Exec > Global Configuration > Context Configuration > IuPS Service Configuration
configure > context context_name > iups-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx-iups-service)#
Syntax
[ no ] inter-rnc-procedures [ source-rnc-as-target-rnc | use-old-location-info ]
no
Disables SRNS relocation when the source RNC is behaving as the target RNC. This is the default behavior.
source-rnc-as-target-rnc
Configures the SGSN to complete SRNS relocation when the source RNC is behaving as the target RNC. For
example, in the case of a Femtocell-to-Femtocell handoff - the femtocell gateway may act both as the source
and target RNC to the femtocells, although from the SGSN’s perspective it is the same RNC.
example, in the case of a Femtocell-to-Femtocell handoff - the femtocell gateway may act both as the source
and target RNC to the femtocells, although from the SGSN’s perspective it is the same RNC.
use-old-location-info
Selects and uses the old values of LAC, RAC and SAC for S-CDRs and ULI information sent to the GGSN
during an intra-SRNS procedure.
during an intra-SRNS procedure.
Usage
Use this command to enable/disable SRNS relocation when the source RNC is behaving as the target RNC.
Example
Enter this command to enable SRNS relocation for those scenarios where the source RNC is behaving as the
target RNC.
target RNC.
inter-rnc-procedures source-rnc-as-target-rnc