Cisco Cisco Packet Data Interworking Function (PDIF)
IuPS Service Configuration Mode Commands
▀ iu-hold-connection
▄ Command Line Interface Reference, StarOS Release 17
6754
iu-hold-connection
Defines the type and duration of the Iu hold connection.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > IuPS Service Configuration
configure > context context_name > iups-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx-iups-service)#
Syntax
iu-hold-connection [ always | requested-by-ms ] [ hold-time seconds ]
default iu-hold-connection
no iu-hold-connection
default
Resets the Iu hold connection parameters to requested-by-ms and 100 second duration.
no
Removes the configuration information for the specified Iu hold connection parameter.
always
Specifies that there is always to be an Iu hold connection procedure.
requested-by-ms
Specifies that there is only an Iu hold connection procedure if requested by the MS/UE.
This is the default setting for Iu-hold-connection.
This is the default setting for Iu-hold-connection.
hold-time time
This variable configures the interval (in seconds) that the SGSN holds the Iu connection.
time:
must be an integer from 1 to 3600.
time:
must be an integer from 10 to 3600.
Important:
It is recommended to use a minimum value of “10” seconds. If a value less than “10” seconds is
used, more collisions may be observed. If the minimum value of “1” is set, after a re-load, INTRA-RAU (with unknown
ptmsi, old-rai known) will be released in “1” second if the Identity Rsp does not come within “1” second.
ptmsi, old-rai known) will be released in “1” second if the Identity Rsp does not come within “1” second.
Default is 100.